eMailPrint this page


Gerätebau GmbH
Mühlstrasse 19
D-76889 Barbelroth
(near Bad Bergzabern)

+49 6343 / 21 39 or
+49 6343 / 61 45 4
+49 6343 / 50 94

© 2010 by NTS

Powerd by
XSI - Site Development Server
Dear customer,

we are pleased that you have chosen the Beli Vine Binding Tool and hope that it will serve you well for a long time to come.

Abb. 1To get the best from the tool, it is necessary to familiarize yourself with it.
Place the binding tool in front of you as shown on the right.

Note the binder wire tip is shown in the picture pointing to the left but that in your new tool it points to the right.

We have done this delibertately to rule out any mistakes before first using the tool.
Leave the wire in this position for the time being.

Now take the tool in your hand and close it. You will now see that the shaft with the ratchet rotates one-sixth of a turn and the return stop engages.

This occurs on each opening and closing.

This brings one of the threewire catchers or one of the three shearing blades into use in sequence.
Now arrange the end of the wire so that it is approimately 1 cm towards the left in the direction of the press-in device, as shown in the topright illustration.
The tool is now ready for use.