1. Pass the tool in the open position over the tie wire and vine widly ...	2. ...without using too much force close the tool until the wire is clampen in the aperture
3. Open the tool again and withdraw it so that ...	4. ...it can be closed just in front of the tie wire and vine The closer to the vine the tighter the binding.
5. Close the tool without using too much force until a slight click is heard. The loop is now clamped in the aperture.	6. Open the tool again and lift it off while still open until the the wire loop is pulled out of the head.
Example of a tight binding	Take it slowly and carefully to begin with! After a little familiarization you will then be able to work confidently and quickly.